If you are currently running Windows in RAID mode, and you switch the setting to AHCI, you will likely be unable to boot Windows. You can either reinstall Windows, or use the method below to convert a running system to AHCI:
1. Open an Administrator Command Prompt or Administrator PowerShell window.
2. Type: bcdedit /set safeboot minimal
Note: If the above command does not work type: bcdedit /set {current} safeboot minimal
This will set Windows to enter Safe Mode on next boot.
3. Type: shutdown /r /fw /t 0
This will reboot the system and automatically go into the BIOS settings.
4. Change the SATA mode from RAID or IDE to AHCI.
Note: If your motherboard allows NVMe RAID in AHCI mode, make sure it is disabled.
Consult your system documentation for instructions to change these settings.
5. Exit Saving changes. The system will now boot into Safe Mode.
6. Open an Administrator Command Prompt or Administrator PowerShell window.
7. Type: bcdedit /deletevalue safeboot
Note: If the above command does not work type: bcdedit /deletevalue {current} safeboot
8. Reboot the system and it should load Windows normally.
If for some reason this method doesn't work for you, you should be able to switch your setting back to RAID and boot normally.
Related Articles
System Requirements For FuzeDrive
Is my system compatible with Enmotus FuzeDrive™? FuzeDrive installation is simple and only takes about 5 minutes. Remember, always back up your data prior to installation of any new software. FuzeDrive requires Windows 10, and is compatible with ...
System Information Required for Support Tickets
Before contacting support, please ensure you have read the FAQ, the online Knowledge Base and also the User Guide to see if these help. If they do not answer your questions, then when submitting a ticket to the Enmotus support team, if possible, ...
Known Software Conflicts
Disk Caching Software [all versions] FuzeDrive is not designed nor guaranteed to work with any third party disk caching software (e.g., Samsung RAPID, Crucial Momentum Cache, PrimoCache) as it requires full access to the raw disk devices. Please ...
FuzeDrive/FuzionX/StoreMI v1.5+ Known Issues
General Issues: To install, your system must be in AHCI mode. For instructions to convert from RAID or IDE mode to AHCI, see <https://support.zoho.com/portal/enmotus/kb/articles/converting-system-from-raid-or-ide-mode-to-ahci>. Some software ...
FuzeDrive/FuzionX - What's New and Changelog
What's New in v1.8 Support for FuzeDriveSSD P145/P146 Fix issue with Sabrent NVMes in 4K mode Fix for ASUS motherboards that report GPT corruption after a create What's New Since StoreMI v1.5 FuzeDrives can be completely unfuzed Fix for conflict with ...